|
A. For most home theater systems, you’ll use a standard RCA connector hookup. This is a shielded wire that is similar in construction to the wires leading from a DVD player to a receiver. It will connect to the single SUB or LFE jack on the back of your receiver and to either of the two inputs on the back of the sub. If you wish, you may obtain a ‘Y’ connector to hook up to both of the sub inputs; this will result in a slight increase in volume.
Cables specifically designed for subwoofer use typically are better shielded than standard ‘patch cables’ and may offer possible noise reduction or cancellation from electrical devices the cable may come in contact with. Some subwoofer cables are directional, (one end always hooks up to receiver, the other to the sub), so always read any instructions that come with your specialty cabling.
Settings in the receiver’s menu system are detailed in the owner’s manual. Here are some suggestions for getting the best possible sound and reliability from your Quintet III with subwoofer system:
• Set all speakers to SMALL setting within the speaker setup controls,
• Adjust the crossover (or Low Pass filter) to 110 or 120 Hz.
• Set the LFE out to SUB ONLY (options might include mains or sub + mains)
Settings on the SUB rear panel are as follows:
• Set the gain/volume to 8 to begin with; you’ll fine tune the balance with receiver remote control.
• Set the low pass/crossover dial fully clockwise to 120. This eliminates the sub’s filter system.
• Set the phase switch to ‘0’; you won’t be using this with the Quintet system.
• Set the ON/OFF switch near the power cable to ON. This is the master power switch.
• Set the auto/ON switch to AUTO. The sub will sense when music or a soundtrack is present and
automatically turn the power on. It will wait a few minutes after the end of the movie to shut off.
If your receiver came with an ‘optimizer’ microphone and setup system, make sure to check the receiver’s settings after running the auto-setup. It is important that your speakers remain set to the SMALL setting. Quintet III satellite speakers cannot reproduce bass tones; allowing the receiver to send bass to them at movie levels might damage them.
|
|
A. The "bass management" option on today's home theater receivers is designed to route mid- or low-bass or both frequencies to a subwoofer in the system. What setting you should select is based on the bass capabilities of the speakers in question.
In general, "satellite" and bookshelf speakers should be set to "small." Floor-standing speakers should be set to "medium" or "large" depending on their ability to accurately reproduce deeper bass. At the same time this option is set, the frequency of the subwoofer's bass reproduction should also be set. If, for example, you have small bookshelf speakers you have set to "small", you should set your subwoofer to 100-120 Hz. If you have big speakers set to the "large" setting, you should set the subwoofer lower (i.e. 50-80 Hz).
The correct settings on both the receiver and subwoofer will allow the subwoofer to pick up the bass where the speaker leaves off; creating a smooth transition that reduces boominess at frequencies both the subwoofer and the speaker are delivering. The correct settings are best obtained after experimentation yields the best sound to your ears.
|